Needhelp
?
| 8051 Core | By Quotes | None | 20 MHz | None |  |
|
| The 8051 has gained great popularity since its introduction and is estimated it is used in a large percentage of all embedded system products. The basic form of 8051 core includes several on-chip peripherals, like timers and counters, additionally there are 128 bytes of on-chip data memory and up to 4K bytes of on-chip program memory. | Introduction | |||||
| UART Serial Interface Controller | By Quotes | None | 300 MHz | None | |
|
| UART compatible Serial Interface Controller with receive and transmit FIFOs and support for all standard bit rates from 9600 to 921600 baud. Applications UART Communications RS232, RS422, RS485 etc. Micro-controller interfacing | Introduction | |||||
| I2C Master Serial Interface Controller | By Quotes | None | 300 MHz | None | |
|
| Master serial controller compatible with the popular Philips® I2C standard. Features a simple command interface and permits multiple I2C slaves to be controlled directly from ASIC device. Supports standard (100 kbits/s), fast (400 kbits/s) and custom data rates well above 4 Mbits/s. Setup and hold-times on the SDA pin are fully configurable. Applications Inter-chip board-level communications Standard 2-wire comms between a wide range of peripherals, MCUs and COTs ICs | Introduction | |||||
| I2C Slave Serial Interface Controller | By Quotes | None | 300 MHz | None | |
|
| Slave serial controller compatible with the popular Philips® I2C standard. Permits an I2C Master to communicate with your ASIC device via a set of user-defined config and status registers. Supports standard (100 kbits/s), fast (400 kbits/s) and custom rates in excess of 4 Mbits/s. Applications I2C slave communication via your ASIC Inter-chip board-level communications | Introduction | |||||
| 8-bit / 16-bit Flash memory controller | By Quotes | None | 200 MHz | None | |
|
| FLASH memory controller ideal for interfacing to a wide range of parallel FLASH memory components . Features a fully synchronous command interface and a set of configurable timing parameters for compatibility with different devices. Applications Any application where non-volatile storage is required Offline storage of parameters and data via your Chip | Introduction | |||||
| DDR4 SDRAM Controller Core | By Quotes | None | None | None | |
|
| Double Data Rate 4 (DDR4) SDRAM Controller Core is designed for use in applications requiring high memory throughput, high clock rates and full programmability. The core uses bank management modules to monitor the status of each SDRAM bank. Banks are only opened or closed when necessary, minimizing access delays. Up to 32 banks can be managed at one time. The core supports all new DDR4 features, including: 3DS device configurations, write CRC, data bus inversion (DBI), fine granu-larity refresh, additive latency, per-DRAM addressability, and temperature controlled refresh. | Introduction | |||||
| Automotive Electronics Platform | By Quotes | None | None | None | |
|
| This Platform can decrease timing for develop. Single Chip Solution Integrated Pressure Sensor Integrated Acceleration Sensor Integrated Temperature Sensor 32-bit RISC CPU PWM RF Transmitter (300-450 Mhz) LF Receiver Easy Integrated Customer’s Logic Application Tire Pressure Monitoring System Automotive electronics | Introduction | |||||
| 1024X8 Flash | By Quotes | None | None | None | |
|
| Nor Flash can be used for code storage and data storage with general purpose MCUs and touch panel controller applications.Application in embedded system. No additional Mask required on Standard CMOS process | Introduction | |||||
| ASK/OOK Transmitter (R433) | By Quotes | None | None | None | |
|
| The IP is a high performance, easy to use, ASK Transmitter IP for remote wireless applications in the 300 to 450MHz frequency band. This transmitter IP is a true “data-in, antenna-out” monolithic device. R433 has three strong attributes: power delivery, operating voltage and operating temperature. In terms of power, the R433 is capable of delivering +10 dBm into a 50Ω load. This power level enables a small form factor transmitter (lossy antenna) such as a key fob transmitter to operate near the maximum limit of transmission regulations. In terms of operating voltage, the R433 operates from 1.8V to 3.6V. Application Garage Door Openers Remote Controls Home Automation Sensor Networks Security System Fan Controllers | Introduction | |||||
| Basic IoT Platform | By Quotes | None | None | None | |
|
| This Platform can decrease timing for develop. Single Chip Solution Integrated Gyroscope Sensor Integrated Acceleration Sensor 32-bit RISC CPU ADC Wi-Fi/Bluetooth SPI/UART/I2C/GPIO Easy Integrated Customer’s Logic Applications Home and Building Automation Smart Energy Internet of Things | Introduction | |||||
| μIP | Price | Logic Gate Count | Clock Rate | Technology | Ratings | |
|---|---|---|---|---|---|---|