Bluetooth 5.2 Dual |
By Quotes |
None |
None |
22 nm |
|
|
This bluebooth is of the lowest power consumption.
|
Introduction |
Bluetooth 5.2 |
By Quotes |
None |
None |
22 nm |
|
|
It's ultra-low-power RF transceiver IP and is designed to meet 2.4 GHz standards.
|
Introduction |
8-Bit 7 GSPS SAR ADC |
By Quotes |
300.000 K μm^2 |
7 GHz |
16 nm |
|
|
This IP is compact and low power 8-bit Time interleaved SAR analog-to-digital converter silicon IP.This ADC uses fully differential SAR architecture optimized for low power and small silicon area.
APPLICATIONS
Serdes Receiver
Coherent Transceivers
Data acquisition
|
Introduction |
MIPI M-PHY Gear 4 IP in TSMC 12nm FFC |
By Quotes |
None |
11 GHz |
12 nm |
|
|
MIPI M-PHY Gear 4 IP is compliant with the latest MIPI.
Alliance M-PHY v4.1 Specification, UniPro v1.8 Specification, and Universal Flash Storage (UFS) v3.0 Specification. A serial interface technology with high bandwidth capabilities and supports HS Gear4 rates up to 11.6Gbps, which is particularly developed for mobile applications to obtain low pin count combined with very good power efficiency. The MIPI M-PHY Gear 4 IP compliant to the RMMI interface which allows UniPro controller and UFS Controller.
|
Introduction |
PCI Express Gen4 PHY IP in TSMC 12nm FFC |
By Quotes |
None |
25 MHz |
12 nm |
|
|
The Peripheral Component Interconnect Express (PCIe) x4 PHY is compliant with PCIe 4.0 Base Specification with support of PIPE v4.4 inter- face spec. Lower power consumption is achieved due to support of addition- al PLL control, reference clock control, and embedded power gating control. Also, since aforementioned low power mode setting is configurable, the PHY is widely applicable for various scenarios under different consideration of power consumption.
|
Introduction |
RC Oscillator |
By Quotes |
0.970 μm^2 |
10.2 Hz |
3 nm |
|
|
The digitally controlled RC oscillators optimized for ultra low power applications.
Application:
• Hand held devices
• Wireless Power devices
• Battery powered stand-by devices
|
Introduction |
8051 Core |
By Quotes |
None |
20 MHz |
None |
|
|
The 8051 has gained great popularity since its introduction and is estimated it is
used in a large percentage of all embedded system products.
The basic form of 8051 core includes several on-chip peripherals, like timers and
counters, additionally there are 128 bytes of on-chip data memory and up to 4K bytes of
on-chip program memory.
|
Introduction |
UART Serial Interface Controller |
By Quotes |
None |
300 MHz |
None |
|
|
UART compatible Serial Interface Controller with receive and transmit FIFOs and support for all standard bit rates from 9600 to 921600 baud.
Applications
UART Communications
RS232, RS422, RS485 etc.
Micro-controller interfacing
|
Introduction |
I2C Master Serial Interface Controller |
By Quotes |
None |
300 MHz |
None |
|
|
Master serial controller compatible with the popular Philips® I2C standard. Features a simple command interface and permits multiple I2C slaves to be controlled directly from ASIC device. Supports standard (100 kbits/s), fast (400 kbits/s) and custom data rates well above 4 Mbits/s. Setup and hold-times on the SDA pin are fully configurable.
Applications
Inter-chip board-level communications
Standard 2-wire comms between a wide range of peripherals, MCUs and COTs ICs
|
Introduction |
I2C Slave Serial Interface Controller |
By Quotes |
None |
300 MHz |
None |
|
|
Slave serial controller compatible with the popular Philips® I2C standard. Permits an I2C Master to communicate with your ASIC device via a set of user-defined config and status registers. Supports standard (100 kbits/s), fast (400 kbits/s) and custom rates in excess of 4 Mbits/s.
Applications
I2C slave communication via your ASIC
Inter-chip board-level communications
|
Introduction |