BOSCH CAN 2.0A/B AND CAN FD 1.0 CONTROLLER |
By Quotes |
None |
None |
None |
|
|
The CAN controller is an I2C/APB compliant controller to act as a transmitter or receiver in the CAN bus.
|
Introduction |
CAN 2.0 & CAN FD Bus Controller Core |
By Quotes |
12.000 K Gates |
None |
None |
|
|
The CAN protocol uses a multi-master bus configuration for the transfer of frames be- tween nodes of the network and manages error handling with no burden on the host processor. The core enables the user to set up economic and reliable links between vari- ous components. It appears as a memory-mapped I/O device to the host processor, which accesses the CAN core to control the transmission or reception of frames.
The CAN core is easy to use and integrate, featuring programmable interrupts, data and baud rates; a configurable number of independently programmable acceptance filters; and a generic processor interface or optionally an AMBA APB, or AHB-Lite interface. It imple- ments a flexible buffering scheme, allowing fine-tuning of the core size to satisfy the requirements of each specific application
|
Introduction |
Bluetooth 5.2 Dual |
By Quotes |
None |
None |
22 nm |
|
|
This bluebooth is of the lowest power consumption.
|
Introduction |
Bluetooth 5.2 |
By Quotes |
None |
None |
22 nm |
|
|
It's ultra-low-power RF transceiver IP and is designed to meet 2.4 GHz standards.
|
Introduction |
Power Controller |
By Quotes |
0.165 μm^2 |
None |
90 nm |
|
|
It is a configurable core that is configured for each specific SoC, delivering all the necessary auxiliary supply, monitoring and protection.
|
Introduction |
4.2V-to-1.8V DC/DC Converter |
By Quotes |
40.000 K μm^2 |
1 Hz |
130 nm |
|
|
The DCDC18 is a 0.13μm DC to DC converter in buck mode cell that converters input voltage to a smaller output voltage. The output voltage can be programmed from 1.65V to 1.9V.An external 10uH inductor is necessary.
|
Introduction |
RC Oscillator |
By Quotes |
0.970 μm^2 |
10.2 Hz |
3 nm |
|
|
The digitally controlled RC oscillators optimized for ultra low power applications.
Application:
• Hand held devices
• Wireless Power devices
• Battery powered stand-by devices
|
Introduction |
Low power oscillator |
12000 Points |
100.100 μm^2 |
32 KHz |
40 nm |
|
|
OSC32K is designed for 40nm advance process with 1.2v to 3.3v wide power(VDD) range.
|
Introduction |
0.13um Real Time Clock |
By Quotes |
None |
32 KHz |
130 nm |
|
|
The RTC is a 0.13μm Real-Time-Clock cell that provides multiple clocks. This RTC provides an operating voltage range of 2.7V ~ 3.3V, and an operating junction temperature range of -40˚ ~ 125℃.
|
Introduction |
Sigma-Delta Stereo CODEC in 55nm |
By Quotes |
562.800 K μm^2 |
96 KHz |
55 nm |
|
|
The IP is a high resolution, single-chip stereo CODEC that employs the Sigma-Delta noise shaping technique for 55nm logic process. The ADC, DAC and power amplifier are integrated in it. With 18bit resolution for DAC and 18bit resolution for ADC, The IP is suitable for applications in consumer digital audio systems, automobile audio, multimedia and digital systems.
|
Introduction |